Your Zphonestand
arrives completely assembled and ready to enhance your daily
usage of your office or home cell phone – camera phone
–
iPod –
or PDA electronic device . But we understand that even with it’s sleek but very rugged design – accidents do happen !
--- - If life might happen to your equipment - Please contact us directly for any needed replacement parts for your phone stand - ---
Also below is a step by step
set of instructions & photos to help you accomplish this replacement task .
Please contact us directly to confirm the current price of your personal stand replacement item.
If you still have any questions about the operation or assembly of your Zphonestand – Please contact us with your inquiries.
Assembling the ZphonestandTMis easy. Just follow these 10 simple steps. Click
on image for full size view.
Step 1
Step 2
Step 3
Step 4
Put the lower and upper arm together and slide
one of the clear nylon washers on the threaded stud.
Slide the stud through the hole.
Place 2 more clear nylon washers – together,
back to back-- in the back on the stud.
Put the thumbnut on the stud.
Step 5
Step 6
Step 7
Step 8
Twist the thumbnut until it is just snug enough
to allow the upper arm to move up and down with slight resistance.
Hand and finger positions for adjusting the
thumbnut.
Slide the single arm to the fully extended
position.
Hand positions for squeezing the cradle together.
Step 9
Step 10
To
Fully Release Your PDA
To release the cradle’s grip,
pinch the thumbnut and twist
the cradle counterclockwise.
Do not twist the phone,
twist the cradle.
Remember – right is tight
(clockwise) -
left is loose
(counterclockwise).
Fully
Rotatable Once your device is installed,
the ZphonestandTM
is fully
rotatable...
Place and center PDA in the cradle and squeeze
the upper arm together with the lower feet. While squeezing,
tighten the thumbnut.
Rotation to landscape – Hold the thumbnut
and twist the feet or am. Pinch thumbnut as PDA arrives
in landscape position which will snug it up.
